No products in the cart.
A4988
Showing all 3 results
- 3D & CNC PRINTER PARTS
CNC Shield V3 Engraving Machine Module/ A4988 Driver Expansion Board for Arduino in Pakistan
-36%
3D & CNC PRINTER PARTSCNC Shield V3 Engraving Machine Module/ A4988 Driver Expansion Board for Arduino in Pakistan
- Using A4988 module
- Five different step mode
- Adjust the maximum current output, so as to obtain a higher rate of step.
- Open source firmware that runs on an Arduino UNO that turns G-code commands into stepper signals
- Can drive four A4988 stepper motor
SKU: CNC SHIELD V3 - 3D & CNC PRINTER PARTS
CNC Shield V4 Engraving machine module/ A4988 Driver Expansion Board for Arduino in Pakistan
-31%
3D & CNC PRINTER PARTSCNC Shield V4 Engraving machine module/ A4988 Driver Expansion Board for Arduino in Pakistan
- 3 axis stepper motor driver
- Compatible with micro-drive laser engraving machine, three-axis CNC engraving machine,.
- 2A can be controlled within the two-phase four-wire stepper motor.
- Released the digital IO interface, easy to connect to other modules, such as END STOP.
- Released the I2C interface, you can connect to the LCD I2C or other I2C module.
- Power DC5V interface, 7.5-12V voltage input.
- GRBL compatible
- Worked with arduino nano.
SKU: CNC SHIELD V4 - 3D & CNC PRINTER PARTS
Stepper Motor Driver A4988 3D Printer Step Stick Carrier Reprap 4-layer PCB RAMPS in Pakistan
-44%
3D & CNC PRINTER PARTSStepper Motor Driver A4988 3D Printer Step Stick Carrier Reprap 4-layer PCB RAMPS in Pakistan
- Simple step and direction control interface
- Six different step resolutions: full-step, half-step, 1/4-step, 1/8-step, 1/16-step, and 1/32-step
- Can interface directly with 3.3 V and 5 V systems
- Over-temperature thermal shutdown, over-current shutdown, and under-voltage lockout
- Short-to-ground and shorted-load protection
- 4-layer, 2 oz copper PCB for improved heat dissipation
- Exposed solder able ground pad below the driver IC on the bottom of the PCB
- Module size, pin out, and interface match those of our A4988 stepper motor driver carriers in most respects (see the bottom of this page for more information)
- Adjustable current control lets you set the maximum current output with a potentiometer, which lets you use voltages above your stepper motor’s rated voltage to achieve higher step rates
- Intelligent chopping control that automatically selects the correct current decay mode (fast decay or slow decay)
- 45 V maximum supply voltage
- Built-in regulator (no external logic voltage supply needed)
SKU: A4988 MOTOR DRIVER